Other Tooling
Machinery Service & Design offers several additional tooling options.
Adjustable Gland Tool | MSD-AGT
The MSD-AGT is used to secure cylinder head glands, tubes, and nuts from 5” (127mm) to 16-3/4” (425mm) in diameter. This tool comes with hardened vise jaws. It was designed to fit onto your existing MSD-ABT base plate. Base plate and L-Brackets are sold separately.
Adjustable Rotation Capture | MSD-ARC
This tool fits our standard Nut Busters®. It is used to rotate cylinder tubes with clevis ends of widths from 2” to 14.”
Support arms can be positioned to capture tube clevis.
In this configuration, the tool is rotating the tube. One option is while the head is secured in a chain vise mounted to a vise elevator.
Adjustable Tool | MSD-AT
Adjustable Tool | MSD-AT
The adjustable tool is supplied with two hardened jaws and can be adjusted from 3” to 9.” This tool can be tightened on cylinders, nuts, heads, glands, or anything that would require rotation for removal or installation.
6” pilot holds the tool steady in the Nut Busters®.
Adjustable tool typical installation in a Nut Buster. This tool has a 4-point contact on round surfaces and will not have the distortion problems that a pipe wrench would have.
Shown here on a hex nut.
Shown here is a typical setup to remove a nut that is not standard.
Concentric Rollers | MSD-CR & MSD-CR-LG
The concentric rollers are used to check concentricity and roundness of hydraulic shafts. They are easily positioned on the slide rails of our disassembly bench to whatever spacing is required for the shaft being checked. The concentric rollers are manufactured with precision roller bearings. A magnetic base dial indicator can be secured to the disassembly bench to check concentricity and roundness of hydraulic shafts.
MSD-CR: 1” (25.4 mm) to 8” (152.4 mm) diameters
MSD-CR-LG: 6” (152.4 mm) to 14” (355.6 mm) diameters
Lock Pin | MSD-LP
Lock Pin | MSD-LP
The MSD-LP lock pins are used to easily and quickly pin the slide plate in place to minimize movement during disassembly and assembly. They are sold in sets of two.
Lock pin inserted through slide plate and disassembly table.
Vacuum Pump System | MSD-VPS
Vacuum Pump System | MSD-VPS
The Machinery Service & Design vacuum system is used to assist the reassembly of hydraulic cylinders. This system takes advantage of atmospheric pressure to simplify the process of entering seals into the bore chamfer and retracting the shaft.
Our two-stage pump delivers high volume and produces vacuum up to 30” of mercury.
